DTC C1AA9: Front Camera Module Beam Axis Not Adjusted [04/2018 - 08/2021]: Description
WARNING: This page is about a different variant/trim than selected.
If forward recognition camera adjustment has not been performed or did not complete normally after the forward recognition camera was replaced with a new one, DTC C1AA9 will be stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AA9 | Front Camera Module Beam Axis Not Adjusted | When the pre-collision system is on, the driving support ECU assembly detects that forward recognition camera adjustment has not been completed for 0.3 seconds or more. | Front camera system |