Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.

NOTE:

When replacing the tire pressure warning ECU and receiver, read the transmitter IDs and number of the transmitters (4 or 5) stored in the old ECU using the Techstream and write them down before removal.
It is necessary to perform initialization. Refer to INITIALIZATION [04/2018 -] after registration. Refer to REGISTRATION [04/2018 - 08/2019] , or refer to REGISTRATION [08/2019 -] of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.