DTC P06DA-13: Engine Oil Pressure Control Circuit Open [04/2018 -]: Procedure

1. Inspect the oil pressure control valve assembly.

   Refer to INSPECTION [04/2018 -]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE OIL PRESSURE CONTROL VALVE ASSEMBLY. Refer to  REMOVAL [04/2018 -] 

Result: 

OK 

See step  2

1. Disconnect the oil pressure control valve assembly connector.
2. Disconnect the ECM connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   C38-1 (OCV+) - C55-21 (VOP+)	Always	Below 1 Ω
   C38-2 (OCV-) - C55-20 (VOP-)	Always	Below 1 Ω
   C38-1 (OCV+) or C55-21 (VOP+) - Body ground and other terminals	Always	10 kΩ or higher
   C38-2 (OCV-) or C55-20 (VOP-) - Body ground and other terminals	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE ECM. Refer to  REMOVAL [04/2018 - 08/2020]  , or refer to  REMOVAL [08/2020 - 08/2021]  , or refer to  REMOVAL [08/2021 -] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR