DTC P0630-51: VIN Not Programmed [04/2018 -]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine / Trouble Codes.
5. Read the DTCs.

   Powertrain > Engine > Trouble Codes 

   NOTE:

   If P0630-51 is output, the VIN must be written to the ECM using the Techstream. However, all DTCs are cleared automatically by the Techstream when the VIN is written. If DTCs other than P0630-51 are output, troubleshoot them first.

   Result

   Result	Proceed to
   DTC P0630-51 is output	A
   DTC P0630-51 and other DTCs are output	B

Result: 

B 

GO TO DTC CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [04/2018 - 08/2019]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [08/2019 - 08/2020]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [08/2020 - 08/2021]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [08/2021 -] 

Result: 

A 

See step  2

1. Write the VIN.

   Refer to REGISTRATION [04/2018 -]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

END