Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
ALL
| Monitor runs whenever the following DTCs are not stored | None |
CASE 1
| All of the following conditions are met | - |
| Permanent fault code | Not stored |
| OBDII system commands | Store |
| Auxiliary battery voltage | 8 V or higher |
CASE 2
| All of the following conditions are met | - |
| Permanent fault code | Stored |
| OBDII system commands | Clear |
| Auxiliary battery voltage | 8 V or higher |
CASE 3
| Auxiliary battery voltage | 8 V or higher |