LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Avalon Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 115 (Engine Control System - Diagnostic Codes [A25A-FXS] (P0520-P107A)) >> SFI System >> DTC P05A2-12: Active Grille Air Shutter "A" Circuit Short to Battery [08/2021 -] >> Procedure

DTC P05A2-12: Active Grille Air Shutter "A" Circuit Short to Battery [08/2021 -]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. PERFORM UTILITY USING TECHSTREAM (SWITCH GRILLE SHUTTER CONTROL MODE) 
    1. Turn the power switch off and wait for 30 seconds or more.
    2. Connect the Techstream to the DLC3.
    3. Turn the power switch on (IG).
    4. Turn the Techstream on.
    5. Enter the following menus: Powertrain / Engine / Utility / Switch Grille Shutter Control Mode.

      Powertrain > Engine > Utility 

      Tester Display
      Switch Grille Shutter Control Mode
    6. According to the display on the Techstream, change the grille shutter control mode from normal mode to maintenance mode.

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  2

  2. PERFORM UTILITY USING TECHSTREAM (GRILLE SHUTTER INITIALIZATION) 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Powertrain / Engine / Utility / Grille Shutter Initialization.

      Powertrain > Engine > Utility 

      Tester Display
      Grille Shutter Initialization
    5. According to the display on the Techstream, perform initialization (nominal torque).

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  3

  3. CLEAR DTC 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Clear the DTCs.

      Powertrain > Engine > Clear DTCs 

    5. Turn the power switch off and wait for at least 30 seconds.

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  4

  4. CHECK DTC OUTPUT (DTC P05A2-12) 
    1. Turn the power switch on (IG).
    2. Turn the GTS on.
    3. Enter the following menus: Powertrain / Engine / Trouble Codes.
    4. Read the DTCs.

      Powertrain > Engine > Trouble Codes 

      Result

      Result Proceed to
      DTC P05A2-12 is not output A
      DTC P05A2-12 is output B

      HINT: 

      Perform "Switch Grille Shutter Control Mode and Grille Shutter Initialization" after replacing the radiator shutter assembly.

      Refer to INITIALIZATION [08/2021 -]

    Result: 

    B 

    REPLACE RADIATOR SHUTTER ASSEMBLY. Refer to  REMOVAL [08/2021 -] 

    Result: 

    A 

    See step  5

  5. READ VALUE USING TECHSTREAM (GRILLE SHUTTER CONTROL MODE) 
    1. Turn the power switch on (IG).
    2. Turn the Techstream on.
    3. Enter the following menus: Powertrain / Engine / Utility / Switch Grille Shutter Control Mode.

      Powertrain > Engine > Utility 

      Tester Display
      Switch Grille Shutter Control Mode
    4. According to the display on the Techstream, change the grille shutter control mode from maintenance mode to normal mode.
    5. Enter the following menus: Powertrain / Engine / Data List / Grille Shutter Control Mode.

      Powertrain > Engine > Data List 

      Tester Display
      Grille Shutter Control Mode
    6. Read the value displayed on the Techstream.

      Standard

      Techstream Display Specified Condition
      Grille Shutter Control Mode Normal

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    END 

scientia non olet · About LEMON Manuals