DTC C1442: Invalid Data Received from Deceleration Sensor; DTC C1443: Invalid Data Received from Yaw Rate Sensor [04/2018 - ]: Procedure

1. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [04/2018 - ]

   Chassis > ABS/VSC/TRAC > Clear DTCs 

2. Turn the power switch off.
3. Turn the power switch on (IG).
4. Check if the same DTC is output.

   Refer to DTC CHECK / CLEAR [04/2018 - ]

   Chassis > ABS/VSC/TRAC > Trouble Codes 

   Result

   Result	Proceed to
   DTCs C1442 and C1443 are not output.	A
   DTCs C1442 and/or C1443 are output.	B

Result: 

A 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [04/2018 - ] 

Result: 

B 

REPLACE AIRBAG ECU ASSEMBLY. Refer to  REMOVAL [04/2018 - 08/2020]  , or refer to  REMOVAL [08/2020 - 08/2021]  , or refer to  REMOVAL [08/2021 - ]