DTC C1440: Steering Angle Sensor Unusual Bank Angle Detected [04/2018 - ]: Procedure

1. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [04/2018 - ]

   Chassis > ABS/VSC/TRAC > Clear DTCs 

2. Turn the power switch off.
3. Turn the power switch on (READY).
4. Perform a road test.
5. Check if the same DTC is output.

   Refer to DTC CHECK / CLEAR [04/2018 - ]

   Chassis > ABS/VSC/TRAC > Trouble Codes 

   Result

   Result	Proceed to
   DTC C1440 is output.	A
   Yaw rate and acceleration sensor DTCs are output.	B
   DTC C1440 is not output.	C

Result: 

B 

REPAIR CIRCUITS INDICATED BY OUTPUT DTCS. Refer to  DIAGNOSTIC TROUBLE CODE CHART [04/2018 - 08/2019]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [08/2019 - 08/2020]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [08/2020 - 08/2021]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [08/2021 - ] 

Result: 

C 

END (VSC TEMPORARILY DISABLED) 

Result: 

A 

See step  2

1. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [04/2018 - ]

   Chassis > ABS/VSC/TRAC > Clear DTCs 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

END