Monitor Description
WARNING: This page is about a different variant/trim than selected.
When the voltage at terminal STP is outside the range of that when the stop light switch assembly is on or the range of that when the stop light switch assembly is off for a certain amount of time, the skid control ECU (brake booster with master cylinder assembly) judges that there is an open in the stop light switch assembly circuit and illuminates the MIL and stores a DTC.
Also, if the voltage at terminal STP is always within the range of that when the stop light switch assembly is on after the vehicle is driven at a certain speed or more and stopped a specific number of times, the skid control ECU (brake booster with master cylinder assembly) judges that the stop light switch assembly is stuck on and illuminates the MIL and stores a DTC.