Removal [04/2018 - 08/2021]: Procedure

WARNING: This page is about a different variant/trim than selected.

PRECAUTION
NOTE:
- After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
  Refer to PRECAUTION [04/2018 -]
- When replacing the auxiliary battery, use a new auxiliary battery of the same dimensions and same capacity or more from the same class at a 20-hour rate.
- After replacing the auxiliary battery, install the ventilation hole plug supplied with the new auxiliary battery or the ventilation hole plug from the old auxiliary battery to the ventilation hole on the side to which the battery hose is not connected.
REMOVE LUGGAGE TRIM SERVICE HOLE COVER
Refer to PROCEDURE - Step 2 [04/2018 - 08/2019] , or refer to PROCEDURE - Step 2 [08/2019 - 08/2021]
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Refer to PROCEDURE - Step 3 [04/2018 - 08/2019] , or refer to PROCEDURE - Step 3 [08/2019 - 08/2021]
REMOVE AUXILIARY BATTERY
Refer to PROCEDURE - Step 4 [04/2018 - 08/2019] , or refer to PROCEDURE - Step 4 [08/2019 - 08/2021]