Wireless Charger Illumination Circuit [04/2018 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL)
- Disconnect the G12 mobile wireless charger cradle assembly connector.
- Measure the voltage according to the value(s) in the table below.
Standard Voltage
Tester Connection Condition Specified Condition G12-10 (TAIL) - Body ground Taillight off Below 1 V Power switch off, taillight on 11 to 14 V Result
Proceed to OK NG
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result:
OK
See step 2
- CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - MOBILE WIRELESS CHARGER CRADLE ASSEMBLY)
- Disconnect the G16 combination meter assembly connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition G16-1 (ILL-) - G12-9 (ILL-) Always Below 1 Ω G16-1 (ILL-) or G12-9 (ILL-) - Body ground Always 10 kΩ or higher Result
Proceed to OK NG
Result:
OK
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [04/2018 - ]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR