LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Avalon Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Transfer Case (Service Information)) >> TRANSFER CASE FRONT OIL SEAL (for RH Side) >> Replacement [08/2020 -] >> Procedure

Replacement [08/2020 -]: Procedure

WARNING: This page is about a different car, the 2021 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH 

    Refer to PROCEDURE - Step 9

  2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH 

    Refer to PROCEDURE - Step 8

  3. REMOVE NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 10

  4. REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 11

  5. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH 

    Refer to REMOVAL [08/2020 - 08/2021] , or refer to REMOVAL [08/2021 -]

  6. REMOVE DRIVE SHAFT BEARING BRACKET 

    Refer to PROCEDURE - Step 1

  7. REMOVE TRANSFER CASE OIL SEAL RH 
    1. Using SST, remove the transfer case oil seal RH from the transfer assembly.
      • SST: 09308-00010 
      NOTE:

      Do not scratch the press-fitting surface of the transfer case oil seal RH.

      GTY957760Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Transfer Case Oil Seal RH
  8. INSTALL TRANSFER CASE OIL SEAL RH 
    1. Coat the lip of a new transfer case oil seal RH with MP grease.
    2. Using SST and a hammer, tap in the transfer case oil seal RH to the transfer assembly as shown in the illustration.
      GTY958192Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Transfer Case Oil Seal RH
      • SST: 09631-32020 
      • SST: 09950-60021 
        1. 09951-00680
      • SST: 09950-70010 
        1. 09951-07360

      Drive in Depth (A)

      7.5 to 8.5 mm (0.296 to 0.334 in.)

      NOTE:
      • Tap the transfer case oil seal RH uniformly so that the transfer case oil seal RH is straight.
      • Do not tap the transfer case oil seal RH in too far.
  9. INSTALL DRIVE SHAFT BEARING BRACKET 

    Refer to PROCEDURE - Step 49

  10. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH 

    Refer to INSTALLATION [08/2020 -]

  11. INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 70

  12. INSTALL NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 71

  13. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH 

    Refer to PROCEDURE - Step 72

  14. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH 

    Refer to PROCEDURE - Step 73

scientia non olet · About LEMON Manuals