LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Avalon Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Engine Cooling System (Service Information) [A25A-FKS]) >> Thermostat >> Installation [08/2020 - ] >> Procedure

Installation [08/2020 - ]: Procedure

WARNING: This page is about a different car, the 2021 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY 
    1. Install a new gasket to the water inlet with thermostat sub-assembly.

      HINT: 

      Be sure to clean the contact surfaces.

    2. Using an 8 mm socket wrench, install the water inlet with thermostat sub-assembly with the 2 bolts.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

    3. Connect the No. 7 water by-pass hose to the water inlet with thermostat sub-assembly and slide the clip to secure it.
    4. Connect the water inlet with thermostat sub-assembly connector.
  2. CONNECT NO. 2 RADIATOR HOSE 

    Refer to PROCEDURE - Step 34

  3. INSTALL GENERATOR ASSEMBLY 

    Refer to INSTALLATION [08/2020 - ]

  4. ADD ENGINE COOLANT 

    Refer to PROCEDURE - Step 2

  5. INSPECT FOR COOLANT LEAK 

    Refer to PROCEDURE - Step 1

scientia non olet · About LEMON Manuals