Caution / Notice / Hint

WARNING: This page is about a different car, the 2021 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during radiator assembly removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Front bumper assembly	Measurement of ultrasonic sensor detection angle Ultrasonic sensor detection angle registration	Intelligent Clearance Sonar System Intuitive Parking Assist System	Refer to CALIBRATION [04/2018 - ]
Front bumper assembly	Front television camera view adjustment	Panoramic View Monitor System	Refer to CALIBRATION [04/2018 - ]
Headlight assembly LH Headlight ECU sub-assembly LH	Synchronize the vehicle information	Lighting system (for Gasoline Model with Cornering Light)	Refer to INITIALIZATION [04/2018 - ]