Replacement [08/2020 - ]: Procedure

WARNING: This page is about a different car, the 2021 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.

REPLACE RING PIN

NOTE:

It is not necessary to remove the ring pins unless they are being replaced.

Remove the 12 ring pins.

Using a plastic hammer, install 12 new ring pins.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Top Side	*b	Bottom Side
*c	Protrusion Height	*d	14 mm (0.551 in.)
*e	12 mm (0.472 in.)	-	-

Standard Protrusion Height

5.0 to 7.0 mm (0.197 to 0.276 in.)

REPLACE STRAIGHT PIN

NOTE:

It is not necessary to remove the straight pins unless they are being replaced.

Remove the 10 straight pins.

Using a plastic hammer, install 10 new straight pins.

*a	Front Side	*b	Rear Side
*c	LH Side	*d	Bottom Side
*e	RH Side	*f	Protrusion Height
*g	22 mm (0.866 in.)	*h	10 mm (0.394 in.)
*i	14 mm (0.551 in.)	*j	6.0 mm (0.236 in.)

Standard Protrusion Height

Straight Pin	Specified Condition
(A)	11.0 to 13.0 mm (0.433 to 0.512 in.)
(B)	5.0 to 7.0 mm (0.197 to 0.276 in.)