Disassembly [08/2020 - ]: Procedure

WARNING: This page is about a different car, the 2021 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE SHIFT POSITION INDICATOR

Disengage the 2 clamps to disconnect the wire harness.

GTY937973

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the 2 screws.

GTY891767

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Disengage the 2 claws and remove the shift position indicator from the rear upper console panel sub-assembly.

GTY937972

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE INDICATOR LIGHT WIRE SUB-ASSEMBLY

Disconnect the indicator light wire sub-assembly connector.

GTY936765

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Disengage the clamp and guide to remove the indicator light wire sub-assembly from the shift position indicator.

GTY906153

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Guide
*b	Clamp

Disengage the claw to remove the clamp from the indicator light wire sub-assembly.

GTY886307

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using a screwdriver with its tip wrapped with protective tape, release the secondary lock.

GTY923294

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Secondary Lock
*b	Protective Tape

Using SST, release the locking lug of each terminal and remove the terminal from the connector housing.

GTY858132

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	Connector Housing
*a	Rear view of wire harness connector
	Shift Position Indicator Terminal

SST: 09991-00510

NOTE:

Before removing the terminals, make a note of the color of each wire and position where its terminal is installed.

REMOVE LOWER POSITION INDICATOR HOUSING

Disengage the 4 claws and 2 guides to remove the lower position indicator housing from the shift lock control unit assembly.

GTY754917

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NOTE:

Do not damage the lower position indicator housing.