LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Avalon Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Automatic Transmission (Service Information) [UB80F]) >> Park / Neutral Position Switch >> Inspection [08/2020 - ] >> Procedure

Inspection [08/2020 - ]: Procedure

WARNING: This page is about a different car, the 2021 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY 
    1. Measure the resistance according to the value(s) in the table below when the transmission control shaft lever is moved to each position.
      GTY502918Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Park/Neutral Position Switch Assembly)

      Standard Resistance

      Tester Connection Condition Specified Condition
      4 (B) - 9 (L) Shift lever in P or N Below 1 Ω
      1 (RB) - 3 (PL) Shift lever in P Below 1 Ω
      1 (RB) - 2 (RL) Shift lever in R Below 1 Ω
      1 (RB) - 8 (NL) Shift lever in N Below 1 Ω
      1 (RB) - 7 (DL) Shift lever in D, S, "+" or "-" Below 1 Ω
      4 (B) - 9 (L) Shift lever not in P or N 10 kΩ or higher
      1 (RB) - 3 (PL) Shift lever not in P 10 kΩ or higher
      1 (RB) - 2 (RL) Shift lever not in R 10 kΩ or higher
      1 (RB) - 8 (NL) Shift lever not in N 10 kΩ or higher
      1 (RB) - 7 (DL) Shift lever not in D, S, "+" or "-" 10 kΩ or higher

      If the result is not as specified, replace the park/neutral position switch assembly.

scientia non olet · About LEMON Manuals