Removal [08/2020 - ]: Procedure

WARNING: This page is about a different car, the 2021 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.

PRECAUTION
NOTE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Refer to PRECAUTION [04/2018 - ]
CHANGE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM SETTINGS (for Power Tilt and Power Telescopic Steering Column)
Refer to PROCEDURE - Step 2 [04/2018 - 08/2021] , or refer to PROCEDURE - Step 2 [08/2021 -]
REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
Refer to REMOVAL [08/2020 - 08/2021] , or refer to REMOVAL [08/2021 - ]
REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH
Refer to PROCEDURE - Step 3
REMOVE LOWER INSTRUMENT PANEL FINISH PANEL RH
Refer to PROCEDURE - Step 4
REMOVE FRONT CONSOLE UPPER PANEL GARNISH
Refer to PROCEDURE - Step 5
REMOVE CONSOLE BOX POCKET SUB-ASSEMBLY
Refer to PROCEDURE - Step 6
REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 7
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
Refer to PROCEDURE - Step 1
REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 9
REMOVE CONSOLE BOX BEZEL
Refer to PROCEDURE - Step 11
REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL
Refer to PROCEDURE - Step 13 [04/2018 - 08/2021] , or refer to PROCEDURE - Step 13 [08/2021 - ]
REMOVE CENTER NO. 2 INSTRUMENT CLUSTER FINISH PANEL
Refer to PROCEDURE - Step 14 [04/2018 - 08/2021] , or refer to PROCEDURE - Step 14 [08/2021 - ]
REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET
Refer to PROCEDURE - Step 9
REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 24 [04/2018 - 08/2021] , or refer to PROCEDURE - Step 24 [08/2021 - ]
REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
Refer to PROCEDURE - Step 11 [04/2018 - 08/2021] , or refer to PROCEDURE - Step 11 [08/2021 - ]
REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL
Refer to PROCEDURE - Step 25 [04/2018 - 08/2021] , or refer to PROCEDURE - Step 25 [08/2021 - ]
REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY
Refer to PROCEDURE - Step 29 [04/2018 - 08/2021] , or refer to PROCEDURE - Step 29 [08/2021 - ]
REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
Refer to PROCEDURE - Step 30 [04/2018 - 08/2021] , or refer to PROCEDURE - Step 30 [08/2021 - ]

REMOVE ENGINE SWITCH

Disengage the 2 claws and remove the engine switch from lower instrument panel finish panel assembly.