LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Avalon Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Engine Lubrication System (Service Information) [A25A-FKS]) >> Oil Pressure And Temperature Sensor >> Removal [08/2020 - ] >> Procedure

Removal [08/2020 - ]: Procedure

WARNING: This page is about a different car, the 2021 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH 

    Refer to PROCEDURE - Step 9

  2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH 

    Refer to PROCEDURE - Step 8

  3. REMOVE NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 10

  4. REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 11

  5. REMOVE OIL PRESSURE AND TEMPERATURE SENSOR 
    1. Disconnect the oil pressure and temperature sensor connector.
    2. Using a 24 mm deep socket wrench, remove the oil pressure and temperature sensor.
      GTY866936Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      If the oil pressure and temperature sensor is dropped or subjected to a strong impact, replace it with a new one.

scientia non olet · About LEMON Manuals