LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Avalon Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Engine Control System (Service Information) [A25A-FKS]) >> Accelerator Pedal >> Installation [08/2020 - ] >> Procedure

Installation [08/2020 - ]: Procedure

WARNING: This page is about a different car, the 2021 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL ACCELERATOR PEDAL 
    1. Engage the claw to install the accelerator pedal.
      GTY787642Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the 2 bolts.

      Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf) 

  2. INSTALL ACCELERATOR PEDAL PAD 
    1. Engage the 4 claws to install the accelerator pedal pad to the accelerator pedal.
  3. INSTALL ACCELERATOR PEDAL(W/SENSOR) ROD ASSEMBLY 
    NOTE:
    • Avoid physical shock to the accelerator pedal sensor assembly.
    • Do not disassemble the accelerator pedal sensor assembly.
    • The accelerator pedal sensor assembly does not require lubrication.
    • Do not apply oil or other lubricants to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.
    1. Connect the rod of the accelerator pedal sensor assembly to the accelerator pedal and install the accelerator pedal sensor assembly with the 3 nuts.

      Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf) 

    2. Connect the accelerator pedal sensor assembly connector.
  4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 47

scientia non olet · About LEMON Manuals