Removal [08/2020 - ]: Procedure

WARNING: This page is about a different car, the 2021 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE REAR WHEEL LH
Refer to PROCEDURE - Step 1

REMOVE NO. 2 FUEL TANK FILLER PIPE PROTECTOR

Remove the fuel tank cap assembly.
Remove all necessary screws and clips and pull back the rear wheel house liner LH to the extent that the inlet fuel tank pipe sub-assembly can be accessed.

*1	Inlet Fuel Tank Pipe Sub-assembly
*2	No. 2 Fuel Tank Filler Pipe Protector
*a	Pull up
*b	Pull off
*c	Hold

While holding the inlet fuel tank pipe sub-assembly, disengage the claws of the No. 2 fuel tank filler pipe protector and pull the No. 2 fuel tank filler pipe protector off of the inlet fuel tank pipe sub-assembly.