LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Avalon Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Fuel System (Service Information) [A25A-FKS]) >> Fuel Pressure Sensor >> Removal [08/2020 - ] >> Procedure

Removal [08/2020 - ]: Procedure

WARNING: This page is about a different car, the 2021 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE FUEL (ENGINE ROOM SIDE) PUMP ASSEMBLY 

    Refer to REMOVAL [08/2020 - ] 

  2. REMOVE NO. 2 FUEL PRESSURE SENSOR 
    1. Disconnect the No. 2 fuel pressure sensor connector.
      GTY948293Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using an 8 mm socket wrench, remove the bolt, No. 2 fuel pressure sensor and No. 2 fuel pressure sensor holder from the fuel delivery pipe sub-assembly.
      GTY948291Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the O-ring from the No. 2 fuel pressure sensor.
      GTY823425Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals