Installation [08/2020 - ]: Procedure
WARNING: This page is about a different car, the 2021 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL FUEL PRESSURE SENSOR
HINT:
Perform "Inspection After Repair" after replacing the fuel pressure sensor.
Refer to INITIALIZATION [08/2020 - ]
- Temporarily install a new fuel pressure sensor to the fuel delivery pipe as shown in the illustration.
*a Cutout (Fuel Delivery Pipe) *b Cutout (Fuel Pressure Sensor) NOTE:Make sure that the cutout of the fuel delivery pipe is aligned with the cutout of the fuel pressure sensor.
- Temporarily install the No. 1 fuel pressure sensor holder to the fuel delivery pipe as shown in the illustration.
*a Cutout (Fuel Pressure Sensor) *b Cutout (No. 1 Fuel Pressure Sensor Holder) NOTE:Make sure that the cutout of the fuel pressure sensor is aligned with the cutout of the No. 1 fuel pressure sensor holder.
- Using an 8 mm socket wrench, install the 2 bolts.
Torque: 10 N*m (02 kgf*cm, 7 ft.*lbf)
- Connect the fuel pressure sensor connector.
- Temporarily install a new fuel pressure sensor to the fuel delivery pipe as shown in the illustration.
- INSTALL INTAKE MANIFOLD
Refer to INSTALLATION [08/2020 - ]
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Refer to PROCEDURE - Step 2
- INSPECT FOR FUEL LEAK
Refer to PROCEDURE - Step 1
- PERFORM INITIALIZATION
- Perform "Inspection After Repair" after replacing the fuel pressure sensor.
Refer to INITIALIZATION [08/2020 - ]
- Perform "Inspection After Repair" after replacing the fuel pressure sensor.