Installation [08/2020 - ]: Procedure
WARNING: This page is about a different car, the 2021 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL PURGE VALVE (PURGE VSV)
- Install the purge valve (purge VSV) to the purge VSV bracket with the bolt.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
*1 No. 1 Fuel Vapor Feed Hose *2 No. 2 Fuel Vapor Feed Hose *a Up *b Front *c 120° *d 2 to 7 mm (0.0787 to 0.276 in.) - Connect the No. 2 fuel vapor feed hose to the purge valve (purge VSV).
- Connect the No. 1 fuel vapor feed hose to the purge valve (purge VSV) and slide the clip to secure it.
HINT:
Engage the clip within the area shown in the illustration.
- Connect the purge valve (purge VSV) connector.
- Install the purge valve (purge VSV) to the purge VSV bracket with the bolt.