DTC P0110-2A: Intake Air Temperature Sensor 1 Bank 1 Signal Stuck in Range [08/2020 - ]: Procedure
WARNING: This page is about a different car, the 2021 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0110-2A)
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTC P0110-2A and other DTCs are output A DTC P0110-2A is output B HINT:
- If any DTCs other than P0110-2A are output, troubleshoot those DTCs first.
- Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly.
Refer to INITIALIZATION [08/2020 - ]
Result:
A
GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2020 - ]
Result:
B
REPLACE MASS AIR FLOW METER SUB-ASSEMBLY. Refer to REMOVAL [08/2020 - ]