Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during vacuum warning switch assembly removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Battery terminal is disconnected/reconnected | Perform steering sensor zero point calibration | Lane departure alert system (w/ Steering Control) | Refer to INITIALIZATION [04/2018 - 08/2021] |
| Pre-collision system | |||
| Intelligent Clearance Sonar System* | |||
| Lighting System (for Gasoline Model with Cornering Light) | |||
| Memorize steering angle neutral point | Parking assist monitor system | Refer to INITIALIZATION [04/2018 -] | |
| Panoramic View Monitor System | Refer to INITIALIZATION [04/2018 -] |
*: When performing learning using the Techstream.