Crankshaft Main Oil Seal: Remove & Replace
WARNING: This page is about the Tundra SR, 4.6L Eng VIN M, 4WD, which is a different variant/trim than selected.
Includes: R&I Transmission, Clutch (where applicable) and Flywheel.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| 4.6L Eng,4WD, Rear,w/Single Piece Driveline | 14.5 | 7.6 | B | |
| 4.6L Eng,4WD, Rear,w/Two Piece Driveline | 14.7 | 7.6 | B | |
| Combination Procedure: CRANKSHAFT MAIN OIL SEAL RETAINER: Remove & Replace: | ||||
| Rear | 0.2 | B | ||