Installation [12/2015 - ]: Procedure

INSTALL TIE ROD ASSEMBLY LH
1. Install the lock nut and tie rod assembly LH to the steering rack end sub-assembly until the matchmarks are aligned.
  HINT:
  
  After adjusting toe-in, tighten the lock nut.
INSTALL TIE ROD ASSEMBLY RH
HINT:

Perform the same procedure as for the LH side.
INSTALL STEERING LINK ASSEMBLY
1. Install the steering link assembly with the 2 bolts and 2 nuts.
  Torque: 70 N*m (714 kgf*cm, 52 ft.*lbf)
  NOTE:
  - Make sure to tighten the bolts starting from the left side of the vehicle.
  - Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.
INSTALL STEERING INTERMEDIATE SHAFT ASSEMBLY
1. Align the matchmarks on the steering intermediate shaft assembly and steering link assembly.
2. Install the bolt.
  Torque: 35 N*m (360 kgf*cm, 26 ft.*lbf)
INSTALL FRONT STABILIZER BAR (for 2WD)
(Refer to INSTALLATION [12/2015 - ] )
INSTALL FRONT STABILIZER BAR (for AWD)
(Refer to INSTALLATION [12/2015 - ] )