LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sienna SE, AWD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Air Conditioning System (Service Information) >> ROOM TEMPERATURE SENSOR (for Rear Side) >> Installation [12/2015 - ] >> Procedure

Installation [12/2015 - ]: Procedure

  1. INSTALL COOLER (NO. 2 ROOM TEMPERATURE SENSOR) THERMISTOR 
    1. Engage the 4 claws and install the cooler (No. 2 room temperature sensor) thermistor.
  2. INSTALL QUARTER TRIM PANEL ASSEMBLY LH 

    Refer to PROCEDURE - Step 14 [12/2015 - 11/2017] , or refer to PROCEDURE - Step 18 [11/2017 - ]

  3. INSTALL REAR NO. 2 SEAT OUTER BELT ASSEMBLY LH 
    1. Install the rear No. 2 seat outer belt with the bolt.

      Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf) 

    2. Engage the 3 claws and install the anchor cover.
  4. INSTALL SLIDE DOOR WEATHERSTRIP LH 
  5. INSTALL REAR DOOR SCUFF PLATE LH 

    HINT: 

    Use the same procedure as for the RH side (Refer to PROCEDURE - Step 26 [12/2015 - 11/2017] , or refer to PROCEDURE - Step 30 [11/2017 - ] ).

  6. INSTALL BACK DOOR SCUFF PLATE 

    Refer to PROCEDURE - Step 23 [12/2015 - 11/2017] , or refer to PROCEDURE - Step 27 [11/2017 - ]

  7. INSTALL BACK DOOR WEATHERSTRIP 
scientia non olet · About LEMON Manuals