Installation [08/2016 - ]: Procedure

1. Move the shift lever to N.
2. Temporarily install the park/neutral position switch to the automatic transaxle case sub-assembly with the 2 bolts.
   NOTE:

   Before installing the park/neutral position switch, remove any dirt or rust on the manual valve lever shaft sub-assembly. Be sure to install the park/neutral position switch straight along the manual valve lever shaft sub-assembly while being careful not to deform the plate spring that supports the manual valve lever shaft sub-assembly. If the plate spring is deformed, the park/neutral position switch cannot be installed correctly.

3. Temporarily install the transmission control shaft lever to the park/neutral position switch.
4. Turn the transmission control shaft lever clockwise until it stops, then turn it counterclockwise 2 notches.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	P Position
   *b	N Position

5. Remove the transmission control shaft lever from the park/neutral position switch.
6. Align the protrusion with the neutral basic line.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Neutral Basic Line
   *b	Protrusion

7. Hold the park/neutral position switch in that position and tighten the 2 bolts.

   Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

8. Install the transmission control shaft lever to the manual valve lever shaft sub-assembly with the washer and nut.

   Torque: 12.7 N*m (130 kgf*cm, 9 ft.*lbf) 

9. Connect the park/neutral position switch connector.

1. Connect the transmission control cable assembly to the transmission control shaft lever.
   NOTE:

   Before connecting the transmission control cable assembly, check that the park/neutral position switch and shift lever are in neutral.

Refer to PROCEDURE - Step 63

Refer to PROCEDURE - Step 64

Refer to PROCEDURE - Step 65

Refer to PROCEDURE - Step 3

Refer to PROCEDURE - Step 67

Refer to PROCEDURE - Step 68

Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf) 

See step  1

See step  1

See step  1