LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sienna SE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Fuel System [2GR-FE] (Service Information)) >> Fuel Pressure Regulator >> Removal [12/2015 - 08/2016] >> Procedure

Removal [12/2015 - 08/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY 

    (Refer to REMOVAL [12/2015 - 08/2016] )

  2. REMOVE FUEL SENDER GAUGE ASSEMBLY 

    See step  18

  3. REMOVE FUEL PUMP WITH FILTER ASSEMBLY 

    See step  2

  4. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY 
    1. Using a screwdriver with its tip wrapped in protective tape, remove the fuel pressure regulator assembly from the fuel filter.
      NOTE:

      Slowly pull out the fuel pressure regulator assembly because the O-rings are firmly installed between the fuel pressure regulator assembly and fuel filter.

      GTY476514Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 O-rings from the fuel pressure regulator assembly.
      GTY476516Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals