LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sienna SE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Automatic Transaxle System [U660F] (Service Information)) >> TRANSMISSION WIRE(When Not Using the Engine Support Bridge) >> Installation [12/2015 - 08/2016] >> Procedure

Installation [12/2015 - 08/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL TRANSMISSION WIRE 
    1. Coat the O-ring with ATF.
      GTY726740Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Coat the bolt with ATF.
    3. Install the transmission wire onto the transmission valve body with the lock plate bolt and lock plate.

      Torque: 11 N*m (110 kgf*cm, 8 ft.*lbf) 

    4. Engage the clamp and connect the transmission wire.
    5. Connect the 9 connectors.
  2. INSTALL TRANSMISSION VALVE BODY ASSEMBLY 

    (Refer to INSTALLATION [12/2015 - 08/2016] )

scientia non olet · About LEMON Manuals