LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sienna SE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Automatic Transaxle System [U660F] (Service Information)) >> SPEED SENSOR(When Using the Engine Support Bridge) >> Installation [12/2015 - 08/2016] >> Procedure

Installation [12/2015 - 08/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL TRANSMISSION REVOLUTION SENSOR 
    1. Coat the 2 bolts with ATF.
    2. Install the transmission revolution sensor to the transmission valve body assembly with the 2 bolts.

      Torque: 11 N*m (110 kgf*cm, 8 ft.*lbf) 

    3. Connect the connector.
  2. INSTALL TRANSMISSION VALVE BODY ASSEMBLY 

    (Refer to INSTALLATION [12/2015 - 08/2016] )

scientia non olet · About LEMON Manuals