Inspection [12/2015 - 08/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY

Measure the resistance according to the value(s) in the table below.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

TEXT IN ILLUSTRATION

*a	Component without harness connected (Park/Neutral Position Switch)

Standard Resistance

Tester Connection	Shift Lever Position	Specified Condition
1 (RB) - 2 (RL)	R	Below 1 Ω
1 (RB) - 2 (RL)	Except R	10 kΩ or higher
1 (RB) - 3 (PL)	P	Below 1 Ω
1 (RB) - 3 (PL)	Except P	10 kΩ or higher
1 (RB) - 7 (DL)	D, S, "+" or "-"	Below 1 Ω
1 (RB) - 7 (DL)	Except D, S, "+" and "-"	10 kΩ or higher
1 (RB) - 8 (NL)	N	Below 1 Ω
1 (RB) - 8 (NL)	Except N	10 kΩ or higher
4 (B) - 9 (L)	P	Below 1 Ω
	Except P	10 kΩ or higher
	N	Below 1 Ω
	Except N	10 kΩ or higher

If the result is not as specified, replace the park/neutral position switch.