LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sienna SE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Automatic Transaxle System [U660F] (Service Information)) >> Park / Neutral Position Switch >> Adjustment [12/2015 - 08/2016] >> Procedure

Adjustment [12/2015 - 08/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
  1. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY 
    1. Remove the transmission control shaft lever (Refer to REMOVAL [12/2015 - 08/2016] ).
    2. Loosen the 2 bolts of the park/neutral position switch.
      GTY384689Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Align the protrusions of the park/neutral position switch.
      GTY343094Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION

      *a Protrusion
    4. Hold the park/neutral position switch in position and tighten the 2 bolts.
      GTY384689Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

      NOTE:

      After installing the park/neutral position switch, confirm that the 2 protrusions on the switch are aligned.

    5. Install the transmission control shaft lever (Refer to INSTALLATION [12/2015 - 08/2016] ).
    6. After the adjustment, perform the park/neutral position switch operation check (See step  1).
scientia non olet · About LEMON Manuals