LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sienna SE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Automatic Transaxle System [U660E] (Service Information)) >> ATF TEMPERATURE SENSOR(When Not Using the Engine Support Bridge) >> Installation [12/2015 - 08/2016] >> Procedure

Installation [12/2015 - 08/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL ATF TEMPERATURE SENSOR (TRANSMISSION WIRE) 
    1. Coat a new O-ring with ATF and install it onto the ATF temperature sensor.
    2. Coat the 4 bolts with ATF.
    3. Install the ATF temperature sensor onto the transmission valve body with the 4 bolts and wire harness clamp.
      GTY696785Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION

      *1 Wire Harness Clamp

      Bolt length

      Bolt Length
      A 25 mm (0.984 in.)
      B 85 mm (3.35 in.)

      Torque: 11 N*m (110 kgf*cm, 8 ft.*lbf) 

    4. Engage the clamp and connect the transmission wire.
    5. Connect the connector.
  2. INSTALL VALVE BODY OIL STRAINER ASSEMBLY 

    See step  4

  3. INSTALL TRANSMISSION OIL CLEANER MAGNET 

    See step  5

  4. INSTALL AUTOMATIC TRANSAXLE OIL PAN GASKET 

    See step  6

  5. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY 

    See step  7

  6. INSTALL TORQUE CONVERTER CLUTCH ASSEMBLY 

    See step  9

  7. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY 

    (Refer to INSTALLATION [12/2015 - 08/2016] )

scientia non olet · About LEMON Manuals