LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sienna SE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Automatic Transaxle System [U660E] (Service Information)) >> ATF TEMPERATURE SENSOR(When Not Using the Engine Support Bridge) >> Inspection [12/2015 - 08/2016] >> Procedure

Inspection [12/2015 - 08/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT ATF TEMPERATURE SENSOR (TRANSMISSION WIRE) 
    1. Measure the resistance according to the value(s) in the table below.
      GTY701400Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION

      *a Component without harness connected
      (ATF Temperature Sensor)

      Standard Resistance

      Tester Connection Condition Specified Condition
      1 (THO1) - 2 (E2) 10°C (50°F) 5 to 8 kΩ
      25°C (77°F) 2.5 to 4.5 kΩ
      110°C (230°F) 0.22 to 0.28 kΩ

      If the result is not as specified, replace the ATF temperature sensor.

scientia non olet · About LEMON Manuals