Inspection [12/2015 - 08/2016]: Procedure
WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY
- Measure the resistance according to the value(s) in the table below.TEXT IN ILLUSTRATION
*a Component without harness connected
(Throttle with Motor Body Assembly)Standard Resistance
Tester Connection Condition Specified Condition 1 (M-) - 2 (M+) 20°C (68°F) 0.3 to 100 Ω If the result is not as specified, replace the throttle with motor body assembly.
- Measure the resistance according to the value(s) in the table below.