Installation [12/2015 - 08/2016]: Procedure
WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL MASS AIR FLOW METER
- Install the mass air flow meter with the 2 screws.NOTE:
Make sure that the O-ring is not cracked or does not jump out of position during installation.
- Connect the mass air flow meter connector.
- Install the mass air flow meter with the 2 screws.
- INSTALL FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 11
- INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
(Refer to INSTALLATION [12/2015 - ] )