LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sienna SE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Engine Control System [2GR-FE] (Service Information)) >> Knock Sensor >> Inspection [12/2015 - 08/2016] >> Procedure

Inspection [12/2015 - 08/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT KNOCK SENSOR 
    1. Measure the resistance according to the value(s) in the table below.
      GTY703126Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION

      *a Component without harness connected
      (Knock Sensor)

      Standard Resistance

      Tester Connection Condition Specified Condition
      1 (Ground) - 2 (Output) 20°C (68°F) 120 to 280 kΩ

      If the result is not as specified, replace the knock sensor.

scientia non olet · About LEMON Manuals