Inspection [12/2015 - 08/2016]: Procedure
WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT NO. 2 OXYGEN SENSOR (for Bank 1 Sensor 2)
- Measure the resistance according to the value(s) in the table below.TEXT IN ILLUSTRATION
*a Component without harness connected
(No. 2 Oxygen Sensor)Standard Resistance
Tester Connection Condition Specified Condition 1 (HT1B) - 2 (+B) 20°C (68°F) 11 to 16 Ω 1 (HT1B) - 4 (E2) Always 10 kΩ or higher If the result is not as specified, replace the No. 2 oxygen sensor.
- Measure the resistance according to the value(s) in the table below.
- INSPECT OXYGEN SENSOR (for Bank 2 Sensor 2)
- Measure the resistance according to the value(s) in the table below.TEXT IN ILLUSTRATION
*a Component without harness connected
(Oxygen Sensor)Standard Resistance
Tester Connection Condition Specified Condition 1 (HT2B) - 2 (+B) 20°C (68°F) 11 to 16 Ω 1 (HT2B) - 4 (E2) Always 10 kΩ or higher If the resistance is not as specified, replace the oxygen sensor.
- Measure the resistance according to the value(s) in the table below.