Installation [12/2015 - 08/2016]: Procedure
WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL CRANKSHAFT POSITION SENSOR
- Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.TEXT IN ILLUSTRATION
*1 O-ring NOTE:- When reusing the sensor, inspect the O-ring.
- If the O-ring has scratches or cuts, replace the crankshaft position sensor.
- Install the crank position sensor with the bolt.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
- Connect the crank position sensor connector.
- Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.
- INSTALL W/PULLEY COMPRESSOR ASSEMBLY
(Refer to INSTALLATION [12/2015 - ] )