LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sienna SE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Engine Control System [2GR-FE] (Service Information)) >> Accelerator Pedal >> On-Vehicle Inspection [12/2015 - 08/2016] >> Procedure

On-Vehicle Inspection [12/2015 - 08/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Powertrain / Engine / Data List / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.
    5. Read the values displayed on the Techstream.

      Standard Voltage

      Tester Display Condition Specified Condition
      Accel Sensor Out No. 1 Accelerator pedal is released 0.5 to 1.1 V
      Accelerator pedal is fully depressed 2.6 to 4.5 V
      Accel Sensor Out No. 2 Accelerator pedal is released 1.2 to 2.0 V
      Accelerator pedal is fully depressed 3.4 to 4.8 V

      If the result is not as specified, check the accelerator pedal sensor assembly, wire harness or ECM.

scientia non olet · About LEMON Manuals