LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sienna SE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Engine Control System [2GR-FE] (Service Information)) >> Accelerator Pedal >> Installation [12/2015 - 08/2016] >> Procedure

Installation [12/2015 - 08/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY 
    1. Install the accelerator pedal sensor assembly with the 2 nuts.

      Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

      NOTE:

      Avoid physical shocks to the accelerator pedal sensor assembly.

    2. Connect the accelerator pedal sensor assembly connector.
scientia non olet · About LEMON Manuals