LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sienna SE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Engine Control System [2GR-FE] - Diagnostic Codes (2 Of 3)) >> SFI System >> DTC P0705: Transmission Range Sensor Circuit Malfunction (PRNDL Input) [12/2015 - 08/2016] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

HINT: 

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may by discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

  1. DATA LIST 
    NOTE:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    1. Warm up the engine.
    2. Turn the ignition switch off.
    3. Connect the Techstream to the DLC3.
    4. Turn the ignition switch to ON.
    5. Turn the Techstream on.
    6. Enter the following menus: Powertrain / Engine / Data List / All Data.
    7. Read the values displayed on the Techstream.
      Techstream Display Measurement Item/Range Normal Condition Diagnostic Note
      Shift SW Status (R Range) Park/neutral position switch status:
      ON or OFF
      • ON: Shift lever in R
      • OFF: Shift lever not in R
      		 When shift lever position displayed on Techstream differs from actual position, adjustment of park/neutral position switch or shift cable may be incorrect
      Shift SW Status (P Range) Park/neutral position switch status:
      ON or OFF
      • ON: Shift lever in P
      • OFF: Shift lever not in P
      		 When shift lever position displayed on Techstream differs from actual position, adjustment of park/neutral position switch or shift cable may be incorrect
      Shift SW Status (N Range) Park/neutral position switch status:
      ON or OFF
      • ON: Shift lever in N
      • OFF: Shift lever not in N
      		 When shift lever position displayed on Techstream differs from actual position, adjustment of park/neutral position switch or shift cable may be incorrect
      Shift SW Status (D Range) Park/neutral position switch status:
      ON or OFF
      • ON: Shift lever in D or S
      • OFF: Shift lever not in D or S
      		 When shift lever position displayed on Techstream differs from actual position, adjustment of park/neutral position switch or shift cable may be incorrect
      Sports Mode Selection SW Sport mode select switch status:
      ON or OFF
      • ON: Shift lever in S, "+" or "-"
      • OFF: Shift lever not in S, "+" and "-"
      		 -
scientia non olet · About LEMON Manuals