DTC P0630: VIN not Programmed or Mismatch - ECM / PCM [12/2015 - 08/2016]: Procedure
WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
- READ DTC OUTPUT
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs.RESULT
Result Proceed to DTC P0630 is output A DTC P0630 and other DTCs are output B If any DTCs other than P0630 are output, troubleshoot those DTCs first.
NOTE:If P0630 is stored, the VIN must be input to the ECM using the Techstream. However, all DTCs are cleared automatically by the Techstream when inputting the VIN. If DTCs other than P0630 are stored, check them first.
Result:
B
GO TO DTC CHART
(Refer to DIAGNOSTIC TROUBLE CODE CHART [12/2015 - 08/2016] )
Result:
A
See step 2
- INPUT VIN
- Input the VIN (Refer to REGISTRATION [12/2015 - 08/2016] ).
Result:
NEXT
END