LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sienna SE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Lubrication System [2GR-FE] (Service Information)) >> Engine Oil Cooler >> Removal [12/2015 - 08/2016] >> Procedure

Removal [12/2015 - 08/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
  1. DRAIN ENGINE COOLANT 

    Refer to PROCEDURE - Step 3

  2. DRAIN ENGINE OIL 

    See step  1

  3. REMOVE EXHAUST MANIFOLD ASSEMBLY LH 

    (Refer to REMOVAL [12/2015 - 08/2016] )

  4. REMOVE ENGINE OIL COOLER 
    1. Remove the bolt, 2 clamps and 4 clips, and disconnect the 2 water by-pass hoses.
      GTY717827Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the oil cooler union bolt, oil cooler and O-ring.
      GTY383449Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals