LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sienna SE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Engine Cooling System [2GR-FE] (Service Information)) >> Relay >> On-Vehicle Inspection [12/2015 - 08/2016] >> Procedure

On-Vehicle Inspection [12/2015 - 08/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT COOLING FAN RELAY 
    1. Measure the resistance according to the value(s) in the table below.
      GTY194700Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Resistance

      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied 10 kΩ or higher
      3 - 5 Battery voltage applied to terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the cooling fan relay.

scientia non olet · About LEMON Manuals