LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sienna SE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Starting System [2GR-FE] (Service Information)) >> Relay >> On-Vehicle Inspection [12/2015 - 08/2016] >> Procedure

On-Vehicle Inspection [12/2015 - 08/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT STARTER RELAY 
    1. Check the resistance.
      GTY303374Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Condition Specified Condition
        3 - 5 Battery voltage not applied 10 kΩ or higher
        3 - 5 Battery voltage applied to terminals 1 and 2 Below 1 Ω

        If the resistance is not as specified, replace the relay.

scientia non olet · About LEMON Manuals