LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Sienna SE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Starting System [2GR-FE] (Service Information)) >> Ignition Switch >> Installation [12/2015 - 08/2016] >> Procedure

Installation [12/2015 - 08/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL IGNITION SWITCH ASSEMBLY 
    1. Connect the connector.
    2. Connect the connector clamp to the ignition switch.
    3. Install the ignition switch with the 2 screws.
  2. INSTALL LOWER STEERING COLUMN COVER 

    Refer to PROCEDURE - Step 4

scientia non olet · About LEMON Manuals